RELIABLE AI SOLUTIONS
Just choose the required modification and let the StageX do the job! It doesn’t get easier !
AUTOMATED TUNING
High quality solutions which can be done with just a few clicks
Do not waste your time repeating the same tasks and work more efficiently than ever before! Rely on advanced StageX’s AI algorithms, which delivers ready to use solutions for supported control units. All common tunning tasks like EGR off, DPF off, Lambda, Stage1 and many more are now available for you, by just ticking the box!
ONE-CLICKAI SOLUTION
Restore to ORI
Restoration to ori
AI Stages
Base remapping ofthe ECU to increase vehicle’s performance - Additional modifications not required
Diesel Particulate Filter (DPF) Deactivation
Automatic deactivation of all related functions, allowing the car to run without particulate filter installed in it.
Petrol Particulate Filter (GPF/OPF) Deactivation
Automatic deactivation of all related functions, allowing the car to run without particulate filter installed in it.
Exhaust Gas Recirculation (EGR) Deactivation
Automatic deactivation of all EGR functions, allows to close the EGR valve all the time.
Selective Catalytic Reduction (SCR) Deactivation
Automatic deactivation of all SCR functions, allows the car to run without AdBlue.
Throttle Valve Actuators (TVA) Deactivation
Automatic deactivation of all Throttle Valve Actuators functions and related DTC codes.
Lambda Sensor Deactivation
Automatic deactivation of Lambda Sensor allowing it’s physical removal for de-cat.
Catalyst Deactivation
Automatic deactivation of related sensors allowing physical catalyst removal.
Start/Stop System Deactivation
Automatic deactivation of Start/Stop System, disabling completely auto engine turn offs.
Speed Limiter Deactivation
Automatic deactivation of Speed Limiter, allows the car to run over the manufacturer limit.
Exhaust Flaps Deactivation
Automatic deactivation of Exhaust Flaps, allows the exhaust to have open flaps at all times.
Torque Monitoring Deactivation
Removal of all torque monitoring functions and related DTC codes.
Readiness Calibration
Readiness Calibrations, allows the pass on the on-board test by OBDII connection.
Mass Air Flow Sensor (MAF) Deactivation
Automatic deactivation of MAF functions, allowing it’s complete disconnection.
Cold Start Noise Deactivation
Automatic deactivation of the intended combustion efficiency degradation due to catalyst heating.
Evaporative Emission Control System (EVAP) Deactivation
Automatic deactivation of all related Evaporative Control System functions.
Pops & Bangs
Automatic activation of a pleasant Pops & Bangs from the cars exhaust.
Variable Swirl Actuator (VSA) Deactivation
Automatic deactivation of VSA functions, allowing it’s complete disconnection.
Start/Stop System Inversion
This solution inverses the Start Stop system activation.
AdBlue Dosing Limitation
This solution enables the vehicle to reduce its AdBlue consumption.
Oil Pressure Correction
Automatic correction of faulty low Oil Pressure setup.
Rev Limiter Deactivation
Removal of the rev limiter allows you to rev up above the manufacturer's lock (typically 3000RPM) when stationary.
Map Sensor Recalibration
Predefined settings for the aftermarket map sensors, offering precise control above the stock boost thresholds.
Secondary Air Injection (SAI) Deactivation
Deactivation of the Secondary Air Injection module, allowing you to remove the component without additional problems.
Exhaust Flaps Open
An automatic solution that keeps the exhaust flaps open at all times.
Engine Heat Fix
Redefined temperature setpoints for lower engine heat stress.
NOx Sensor Deactivation
Automatic deactivation of the nitrogen oxide sensor, enabling your car to run without issues related to the sensor.
Half-Engine Mode Deactivation
Deactivation of the half engine mode, making the engine work on all cylinders at all times.
Torque Unlock
TQ Unlock for AI Stage 1 in VAGs
NEWSLETTER
Keep up with us
Join the revolution with StageX
The intelligent engine and transmission remapping software for vehicle recalibration